Posted by pete 23 on February 12, 2013 at 10:18:08 from (74.47.40.242):
In Reply to: 560 Transmission posted by H-66 on February 12, 2013 at 02:48:10:
The flat bower roller bearing on pinion shaft replaced the ball bearing. I am racking my brain here now as I am not sure that it was included in the original up date pkg. I think it came along shortly after but I may be wrong on that. The roller bearing on inside axle was not with the package and came later as did another bearing improvement package. Original tapered roller change over on differential had a high failure rate also so those bearing were changed to a crowned end tapered roller bearing. I know, I put in several sets. The tapered shim on right hand side of differential was included with that later bearing upgrade pkg. That pkg was not a give away except it was at a very low cost to customer. In other words, not all improvemets came at one time and it was not a recall in the sense that customers brought them in at their convenience within a rather long time frame. Took quite a while to get them all done. Been many years so don't remember all the details but I did do ten of them that I can remember.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Old Abe is Still Making Hay - by Jeremy Sweeten. Things have changed a bit since my last article. I am now almost finished graduate school at Purdue University. I am still in Agronomy, but specializing in hay and forages. My wife has survived two years of marriage to a part-time farmer. The equipment line up has changed a bit too. The DC has retired to
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
