Posted by Janicholson on November 26, 2012 at 10:20:58 from (199.17.6.23):
In Reply to: IH 350 gas posted by RBoy on November 26, 2012 at 06:40:44:
The hydraulic system is a modified open center system. it uses a pilot valve to turn on pressure to the system. two solutions on is to find that same tractor with PS and get the PS designed control block and attachments. The other way is to install an engine driven pump. Honda has a nice remote reservoir pump. If it is a Utility Tractor, The conversion is liable to twist too hard on the original gearbox ruining it. If it is a Farmall row crop, there should be no issur, the front shaft above the engine is cut, and couplers are welded on for the torque generator, and brackets to absorb the torque. If it was a Kit it should have the needed brackets. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Generators - by Chris Pratt. As a companion to the articles on three-brush and two-brush generators, it seemed fitting that we should provide our readers with a description of how a generator works in lay terms. The difficulty with all those "theory of operation" texts is that they border on principles of electricity or physics and such. Since I know nothing of either, you will have to put up with looking at the common sense side of how generators work which means we "
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
