Posted by Wardner on October 07, 2012 at 14:49:03 from (4.154.233.245):
In Reply to: Re: IH generator posted by gene bender on October 06, 2012 at 18:51:04:
Gene,
Not sure if you are suggesting that a 460 or 560 could run a side mount Electrall. Absolutely no way on the 460. The 560 would need a new IPTO driving and driven gear which would also affect the speed of the 540 PTO at the rear. That would cause an overspeed. The driving gear would have to come from SMTA, 400, 450. The gears need to be swapped so that the constant mesh Electrall gear can mesh with the IPTO driven gear as shown below.
Kinda hard to imagine a snowplow tractor towing a trailer mount Electrall. They don't back up well due to the short wheelbase.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
