Posted by John T on September 28, 2012 at 09:25:07 from (216.249.82.117):
In Reply to: 12 volt conversion posted by Clifford Hora on September 28, 2012 at 09:03:46:
Ive converted from 6 to 12 and used the old 6 volt starter at 12 volts and never had any problems HOWEVER that can be tough on starter drives and starers and perhaps flywheel ring gear teeth due to such strong initial kick in torque !!!!!!!!!!!!!!!!!!
My self and Ol Bob M have discussed this and are of the opinions when doing this NOT to use a super heavy high capacity battery (like a 1000 CCA, maybe a wimpy 500 CCA instead) orrrrrrrrrrr maybe use lighter gauge (like 4 or 2 instead of 1 or 0) battery cables EITHER OF WHICH can reduce the problem to some extent.
I think Jim or Bob have some recommendations far as the type of starter drive to use??????
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
