Posted by charles todd on September 02, 2011 at 19:06:21 from (205.242.95.132):
In Reply to: Trailer for Farmall H posted by Old-F20 on September 01, 2011 at 12:37:26:
Are you kidding. I use a 20' goose neck on a 1/2 ton Chevrolet for tractors up to an Allis Chalmers 180, Komatsu PC38 excavator, and JD 4010 w/ loader. I also carry 11 round 5x4 round bales of hay with it.
Handles the load well. I have traveled over 360 miles one-way with these loads. 10 years and 151,000 miles, no issues.
I really do not like bumper pulls anymore. Goose neck trailers pull and handle much better. Not to mention they distribute weight better. Before anyone chirps in, I have a 28' camper that I use a weight distributing hitch with and hate the trailer.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
