Wardner, I have an angle iron setup like you are talking about for bending lighter sheet metal. I will make a heavier one for this drawbar project, should work good. Thanks for the picture of the drawbar. Do you happen to have any dimensions (bends, lengths) for that drawbar. Or, do you know if a drawbar for a Farmall 300 would have the same dimensions. I looked at the CaseIH parts site for the 300 and 450 drawbars. Pictures look identical, but part # for a 300 is 368468R11, and for a 450 is 368475R11. The reason I'm asking about a 300 drawbar is that my brother (500 miles away) has a Farmall 300 with a drawbar like the one you sent the picture of. I could get dimensions from him of the 300 drawbar if they would work for a 450 drawbar. I'm wondering if the 300 drawbar may be made of lighter material, but the same length, etc? - and so thus a different part number? Thanks for all of your help!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
