Posted by Wilamayb on May 08, 2010 at 08:17:33 from (71.15.148.196):
My buddy was given an old H if he would get it running. Soooo after a head job (new valves, guides, etc... and milling it a bit we bolted it on with a rebuilt mag and carb and off she went.
Someone installed gas pistons years ago. Combining that with the milled head even though it is distillate it pulls like a champ!
We turned a new garden spot for a guy yesterday with my 44 JD plow set for 14" bottoms. The H runs along with it even in the sod. I was impressed.
This old H it T-totally worn out! I think a share cropper must have owned it. LOL
We have no electronics at this point. The Genny is bad as is the starter $$$$$$ so we are just hand cranking. I'm just glad it's an easy starter! I kid him all the time about having a dead battery.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
