john *.?-!.* cub owner said: (quoted from post at 21:06:56 05/09/10) If you want a thrill, hit a rock that trips the breakaway while you are pulling on that trip rope. You would be amazed how far your arm will stretch before you can think fast enough to let go. :lol:
:lol: :lol: :lol: As the Boy Scouts say, be prepared!
Sounds like the old H is going for about all it is worth. Still runs pretty clean.
Some places where I grew up, the clay causes a lot of run off. To help retain water for the dry months it was/is necessary to do some tillage in those spots. Soften it up for absorption.
Those high speed bottoms sure are different. My old #8 don't like to be pulled all that fast. When it gets too worn, maybe someday it will get some upgrading. :)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
