Posted by Dan G on June 14, 2009 at 14:49:19 from (74.212.33.43):
Ok, guess I'm kinda showing off. You would too after all that work. Finally finished my H. Rebuild the rear end, pto dogs sheared off, replaced with new spline type pto shaft, lower trans shaft, bearings, seals, galore. sand blast and paint from hydro pump back, installed 3 point hitch from Saginaw, sand blast and paint all sheet metal. sand blast, and refurb as seen buzz saw. It actually says "New Holland Machine Company, Combination saw" in the casting. This is a '47 H, but I think the rear is actually older. I haven't dug deep enough yet. New lights, lots of unmentionables.
Tractor going to show coming up july 10 to 12th, in Tunkhannock, PA. Buzz saw and antique 2 row corn planter (IH) is going with it. Looking forward to it!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: Electronic Ignition - by Staff. Oil, for example has come a long way in the last 50 years and I don't use anything but the latest API grade available. I've heard the arguments for non-detergent oils but would never trade it for today's formulations. Paint is another, the modern acrylic enamels are great for resistance to grease and fuel stains, retaining their shine and they last forever; unlike enamels and lacquers . Still another is the alternator. No doubt using the original generator keeps the tractor pure, but for thos
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
