Posted by MN Scott on June 06, 2009 at 12:19:16 from (206.9.216.67):
In Reply to: Re: Woe is me posted by Mr. Mayor on June 06, 2009 at 12:00:14:
I did use a thin coating of rtv on the Case gaskets. Usally I don't use RTV because it can cause more problems that it solves. I like to use the No.3 Permatex brush on gasket sealer but that will not bridge imperfect areas like rtv can. I have had bad luck with aftermarket gaskets mainly Victor Renz. On my 706 I replaced the head gasket. The valve cover gasket and the intake manifold gasket that came with the kit leaked as soon as I started it. I bought the CaseIH gaskets to replace them and not a bit of seepage with them. The Case gaskets were made of a rubber like compound not the cheap cork and paper like the Victor ones. Now when I replace a gasket it comes from CaseIH, it may cost more but I'am not replacing it in a few hours either.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: Storm Covers - by Staff. We recently had a chance to try out the new Storm Cover for the Ford 9N, 2N and 8N tractor that is now being re-introduced to a new generation of Ford N-Series tractor owners. Originally produced more than 40 years ago, it is now enjoying a reproduction run that has been licensed by the Ford Motor Company. An original storm cover was used for the pattern, and this reproduction cover is indeed exactly as the original (of which we had previously only seen pictures of in miscellaneous old sale
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
