Posted by Scott DesJardins on May 08, 2009 at 03:58:12 from (72.237.55.3):
I"m working on a 1962 IH 504 with the D188 motor. It had a broken crankshaft when I picked it up. I have the crank all the bearings and seals but can"t find the balancer assembly available anywhere. Mine was missing from the tractor, but I didn"t discover that until I had everything sufficently removed so I could get at the bottom end and look around. If you look on page 34 of the model 330, 340, 504 2504 section of the IH-201 shop manual, figure IH1335C I am missing numbers 17 thru 22. I"m guessing that the original reason the crank broke is that the previous owner ran the engine without this installed. Any help or suggestions about changing the crank and working on this D188 engine would be appreciated. And if anybody knows where I could find my missing parts please let me know.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
