Posted by RustyFarmall on November 26, 2008 at 05:24:46 from (209.152.78.9):
In Reply to: Help with H posted by b.runyan on November 25, 2008 at 19:47:31:
The mylar decals are more like the original.
The high speed idle, or load adjustment screw should be set at 3 full turns out and then left alone. You stated that if you turn it all the way in, the engine dies. This is normal because in effect, you have just shut off the flow of fuel. The only time that screw should be adjusted is if the engine misses or lacks power while running full throttle under a load. With the engine at a slow idle, adjusting that screw will make NO difference one way or the other.
The slow idle adjustment is a different story, it needs to be set 1 1/2 turns out initially, and then should be turned either in or out very slightly to give the smoothest idle.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
