Posted by Brandon D'Avis on April 12, 2008 at 20:51:06 from (207.200.116.7):
In Reply to: 706 diesel questions posted by Brandon D'Avis on April 11, 2008 at 19:27:49:
All the linkages seem to move freely,and moving the arm on the pump,and it moves the other arm too.
When rebuilding the engine, The head was magnafluxed,resurfaced, and they seated the valves. Using new valves. they said that everything that was needed was fixed on it.
When cranking it,I do get smoke.So I think it is getting fuel? Sorry, new to diesels here.
When it started it was running for maybe 15-20 seconds. But just seemed to run very fast,almost out of control and I didnt want to hurt anything.
So if it was yours would you start it again and see what happens? Is there anyway I can assure myself that it will not "run away" when it starts?
Sorry for all these questions,just new to diesels.
If only it was gas..........then I would know what I was doing.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review - by Staff. When we finally checked out the 3000 PSI North Star, the whole story chaned. This unit was equipped with an 11 HP Honda engine with fuel shutoff, adjustable flow and optional syphon degreaser dispenser. It didn't have a pressure release or electric start to facilitate easy starting but according to the instructions, simply pulling on the trigger while cranking was sufficient. This method of starting proved more than adequate and kept the cost down on the unit. It had all the important
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
