|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Super A , magneto timing
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall & IHC Tractors Discussion Board ]
Posted by Carl on February 13, 2000 at 13:45:05 from (12.73.160.145):
In Reply to: Re: Re: Super A , magneto timing posted by Jim Becker on February 13, 2000 at 09:25:04:
If I understand right, my manual reads to install the mag at TDC #1, "Then crank the engine one complete rev to the next TDC". In reality the next TDC is #3 at 1/2 rev, but the flywheel isn't marked for #3 & #2 so we're going on to #4 just to use the flywheel reference mark to set the coupler timing? At this point, all I need to do is adjust the mesh of the gears in the distributor body, so that the rotor is pointing at #1 plug wire ? ? Chris, funny you should mention pushing snow . . .
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
