|
Farmall & IHC Tractors Discussion Board |
Re: Farmall C oil pump
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by glennster on August 12, 2007 at 16:18:24 from (68.60.242.156):
In Reply to: Farmall C oil pump posted by bbrinks on August 12, 2007 at 15:15:46:
try puting a known good gauge on it first. could be just a bad pressure gauge. if the pressure still reads low, could be the bottom plate on the oil pump is worn. drop the oil pan, and the bottom of the oil pump will have 4 bolts, remove them, and the cover will come off. there is a spring that will come down too, with a metal cup on top. check the surface where the pump gears ride. if there is a groove worn in it, you can use emery cloth on a piece of flat steel or glass and sand it back smooth. i just did this on my farmall b. takes 6 sheet of emery cloth and about an hour and a half of sanding. you will need a new oil pan gasket and pump gasket too.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Talk of the Town: Best Tractor? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew quite a bit of response. We see the question of "Which tractor is best for me?" asked quite often. We thought you might find the responses interesting. As always, the names of the people participating in the discussion have been left out - we did not request their permission to reprint their names in this article. However you can find this discussion in it's entirety in the Tractor Talk archives.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
