|
Farmall & IHC Tractors Discussion Board |
1066 PTO
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JM in Merit on August 07, 2007 at 11:19:26 from (12.39.110.213):
Been cutting hay, got in tractor this morning to move to another field, turned cutter on and mowed a very small patch befor leaving field ( like a 10 feet section I had missed)
Roaded tractor about 2 miles to another field, turned pto on and nothing happened.
Took PTO shaft off and PTO will turn ( both 1000 and 540 shafts). I can turn cutter over by hand ( disc Cutter). If you hookup the shaft to the pto it will start and then stop, you can rev engine up and no dice.
Fluids are full, power sterring is good, remote hydraculics are working ok.
Is it the cluthes in the PTO pump or could it be the screen where fluid is sucked up into the pump? What type of job am I looking at?
Thanks
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
