|
Farmall & IHC Tractors Discussion Board |
Re: Help- 560D Won't Start
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on July 28, 2007 at 20:04:13 from (216.208.58.144):
In Reply to: Help- 560D Won't Start posted by Hal Weaver on July 28, 2007 at 18:02:51:
Hal: Jimmy is right about getting fuel, now having said that and having owned a 560D for 17 years and 11,000 hours, I can tell you I have had the same experience as you, not often but 3-4 times. I just hooked either 300, 656 or 1066 out front and towed it in 4th gear, hi TA with clutch out until it started firing and running smooth. Set your throttle about PTO speed and tow it very close to same speed as 4th at that throttle setting. Don't tow it over speed, best to be a bit under. I have towed my 560 close to half mile, before it started firing. Don't ask me why, I've never figured it out. Each time I did that, after very next shutdown, it fired right up again and never gave anymore problems until next time which was probably 2-3 years later. I've asked many an expert, including IH regional service reps, and still no answer. All they ever told me is I shouldn't have towed it like that to start it. Well guess what, those experts didn't have cows to feed and milk, in other words it didn't affect their cash flow one damn bit. Furthermore, towing the 560 didn't hurt my cash flow one damn bit. I farmed for many years, and my highest net yearly income came from the years the 560 and 656 diesels were my main source of power.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let�s make one more addition to our series on hydraulics. I�ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|