Re: 986 speed transmission cover

Posted by Owen Aaland on June 26, 2007 at 23:20:54 from (65.165.246.40):

In Reply to: 986 speed transmission cover posted by 986feller on June 26, 2007 at 19:31:16:

Since there is no neutral position in the speed transmission, what I usually do is put the transmission in fourth gear. That is all the way forward with the front shift fork. Make sure the other fork is positioned so that the first/second sliding gear is not engaging either first or second gear on the bottom shaft. Rotate the shift cam on the cover so that it it is the fourth gear position. Set the cover down so that the front fork roller engages the cam. Keep the cover slightly lower in the front so the roller stays engaged in the cam. Then, using a long, narrow screwdriver, move the rear fork a little forward or backward until the roller engages and the cover drops down. Be careful not to damage the gasket when moving the fork with the screwdriver.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]