Farmall & IHC Tractors Discussion Board |
Re: Super C Steering Support Bushing
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Skycarp on February 15, 2007 at 18:19:35 from (12.176.204.25):
In Reply to: Re: Super C Steering Support Bushing posted by gene bender on February 15, 2007 at 18:08:07:
Gene, No, this is the support that bolts to the bar that holds all the controls, like touch control levers, lights, throttle, choke, etc. It is about three inches below the steering wheel, is cast, has a zert for grease and a bushing at the upper end where the steering rod rides in. The bushing is about three inches long, split down the middle for ease of installation and has a hole drilled for the grease to enter the space between the steering rod and the bushing. If an original is not available, I will get some bushing stock and turn it to correct ID and OD. I just wanted to put my hands on an original to save some machine work.
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|