|
Farmall & IHC Tractors Discussion Board |
Re: fast hitch 3 pt conversion
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Ronald on February 05, 2007 at 18:39:50 from (205.188.116.133):
In Reply to: fast hitch 3 pt conversion posted by Ronald on February 05, 2007 at 17:44:02:
I already have a top link mount. The spacing fast hitch spacing is 32" same as most 3pt equipmet I will be using. Just wondered if any had the length from a factory hitch to give me correct length for pto. I also think the prongs bend up to compensate for fast hitch not lifting as high as three point. At least some of the factory hitches I have see are like this. I'm sure I can figure it out but I thought somebody else might have already figured it out.
Thanks Ronald
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Identifying Your Tractor - by Staff. Maybe you bought it from a friend who didn't know what kind of tractor it was, or perhaps (and this is every tractor fanatics dream) you stumbled across it in an abandoned field covered with weeds but intact. In any case, you have no idea what the make and/or model is. For awhile perhaps it doesn't really matter. Especially if it runs! But pretty soon you'll probably need to tinker with it a bit and maybe buy a part or too. Having a manual is nice. But how does one go about dete
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
