Farmall & IHC Tractors Discussion Board |
Re: OT: Farmallhal, a new job for our tractors.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by farmallhal on January 29, 2007 at 18:36:07 from (64.85.220.148):
In Reply to: OT: Farmallhal, a new job for our tractors. posted by Hugh MacKay on January 29, 2007 at 17:49:04:
You sure have that task figured out but don't think there is enough mail between the two cities to justify even a 140. I just gave it to a postal clerk at the post office as I didn't know what international postage is between these two countries. I think all first class mail in this country is flown now if any distance is involved. Sometimes it will take the better part of a week to get a letter to a town just down the road less then 30 miles. First, the letter goes to our local post office and then is sent to another location to be sorted along with other mail for the city to where it is to be delivered. Then the letter goes from the sorting facility to the destination city for another route sorting and then to the carrier for delivery. I don't think letters mailed in Rolla going to Rolla are sorted at the local post office any longer. There used to be a mail box in the post office for local mail but that has been gone for at least a couple of years. One thing for sure here in central Missouri the postal workers are the nicest group of folks you will ever be in contact with. Every one of them is very pleasant and will help you with a smile and no task is too much bother. I guess the system we have in place for handling the mail must be more cost effective then timely. Thanks for the post and it must be cold up there to be noticing such things. I was inside most of the day as well and plan to so again tomorrow. Get out early and feed the animals and call it a day on these cold and windy days. Stay warm, Hal
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|