Farmall & IHC Tractors Discussion Board |
Re: OT: Farmallhal, a new job for our tractors.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by farmallhal on January 30, 2007 at 08:28:17 from (64.24.35.16):
In Reply to: Re: OT: Farmallhal, a new job for our tractors. posted by Hugh MacKay on January 30, 2007 at 03:30:11:
Hugh, I certainly didn't take your note to be postal service bashing. I think you are just house bound like we are down here and thinking too hard. I really don't think there is even a US air mail postal rate any longer. I do know it is available for international mail though. I rarely send anything out of the country but did have an uncle in Hawaii I used to send smoked salmon too every Christmas. That I believe was sent first class which meant it flew. When there was a parcel of some weight involved you had a choice of air (which cost more) or boat as parcel post. I usually flew everything to him and it probably went at a class called Priority Mail but again this was still in this country. I spent a lot of time in Canada when I lived in the Seattle area mainly on fishing trips into the interior of British Columbia. It was always a pleasure to visit your country and I met some very wonderful folks in the backwoods. You have better beer and beanne weenees could be found almost anywhere. I always brought back my stash of them whenever visiting Canada. Actually, Mt. St. Helens erupted when I was on a spring fly fishing trip in Canada and didn't even know about it until I crossed the border a week or so later coming back home and the customs folks informed me it happened during the time I was there. Well again today I plan on staying around the house as it is just 10 F and wind chill is -10 F and the animals are already taken care of. Was quite cold out doing the chores and just can't see a reason to be out today. Take care up there and stay warm. Hal
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|