Farmall & IHC Tractors Discussion Board |
Re: C-123 engine applications and serial numbers
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by David Lindsay on December 26, 2006 at 15:29:58 from (216.167.225.224):
In Reply to: Re: C-123 engine applications and serial numbers posted by Stan(VA). on December 25, 2006 at 18:49:49:
I've had a Farmall for 20 plus yrs sitting in my barn and never tried to find out what it was until this week when I found this site. It has been pickled but started up with some gas and a short pull. I'm trying to verify if it is a 1955 Model 200. The engine is embossed C123 and 354898. As well engine is stamped 11347. The plate on the clutch housing is 5900 J. The grill has two vertical full length openings below the IH chrome badge. On either side is a pattern of horizontal openings layed out, two space six space six and space two, which I understand was the pattern after 1954. Any info is appreciated. THx Dave
Replies:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|