|
Farmall & IHC Tractors Discussion Board |
Super A adjustable front end
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Mark in Wa on December 18, 2006 at 04:54:46 from (131.35.138.10):
My super A has the adjustable front end but the pin holes on the outer portion seem to be elongated in several of the inner positions. what have others out there done to restore this to the proper strait up and down position. I do not like it when the vertical part of the spindle pitchs back and am concerned about doing more damage to the front end. I thought of welding the holes, grinding and redrilling but I believe these are cast and that is hard enough to weld without the additional stress, my second thought is to run a bushing completely through the thing. Any help would be much appreciated. I guess whoever has this tractor in the past drove it like they were in NASCAR, not real good for the equipment.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Engine Basics: Spark Plug Cleaning - by Staff. Cleaning procedures: Brush or blow dirt from around the spark plug base. Remove the plug with a correctly fitted wrench. Examine the porcelain insulator and points. If the insulator appears to be melted or blistered, cracked or broken, and the points seem unduly burned it is evident that the plug is operating too hot and it should be replaced with a colder plug. If the plug is fouled excessively with carbon it apparently is operating too cold and it should be replac
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
