|
Farmall & IHC Tractors Discussion Board |
Re: Help Getting Started on my Super-M
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Don L C on December 06, 2006 at 15:32:22 from (71.79.19.153):
In Reply to: Help Getting Started on my Super-M posted by WannaBeCountry on December 06, 2006 at 13:41:22:
The electrical system is a very good place to start.....order the wireing harnes, lay it out and under stand it.......may be tag where each wire will go......you can just swap out the old one just before painting........rebuild the carb. with a complete IHC kit (~$100)......new points, cond. ,rotor and cap.....new spark plugs AC86 or Autolite 386 and wires.....these are things that dont take long,for a cold day....be careful when removing the carb. from the govener...read the directions before you start.......... Binder Books 503 684-2024 has the orignal and the best manuals.........Don
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
