|
Farmall & IHC Tractors Discussion Board |
Re: Tuning a carb????
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by IaGary on November 23, 2006 at 08:13:30 from (69.63.4.238):
In Reply to: Re: Tuning a carb???? posted by Allan In NE on November 23, 2006 at 05:49:21:
All right you guys. I knew I should have told you,this is the one I put electronic ignition and new plugs in about 50 hours ago. Thought that would solve the problem but it didn't. Had a valve job about 250 hrs ago. I'm fairly sure its the carb but I was wrong once or maybe twice before in my life. I'll try Sloroll's method next time I grind a load of feed to put it under a load. Runs great for all other jobs but the grinder pulls hard and after awhile it starts to spit and sputter like its short on fuel. Gary
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
