Farmall Tractors Discussion Board |
Re: More about the locked up M;ever made an engine dolly?
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall Tractors Discussion Board ]
Posted by Steve T on January 29, 2000 at 22:02:08 from (208.150.193.52):
In Reply to: More about the locked up M;ever made an engine dolly? posted by Ray on January 28, 2000 at 18:15:44:
I have to agree with every one that said to take it apart. The easiest thing to do is just pull the head off and take a look. If you find lots of rust, then a complete tear down is in order. If you find only a little bit of rust, then it will be a little easier to un-stick. However, its been my findings that engines that only have a little rust in the cylinders, will usually rust around the rings themselves, and will leave pits and such in the cylinder walls where the rings were, thus needing new sleves, or an overbore, to clean things up. I have seen some people simply free the pistons, and put it back together. Sure, it will run, but how well and how long? Steve T
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|