Farmall & IHC Tractors Discussion Board |
Re: Can I put Super H pistons/sleeves in a 52 H?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Brian in Ne on September 04, 2006 at 06:53:25 from (12.37.227.161):
In Reply to: Can I put Super H pistons/sleeves in a 52 H? posted by Jake Winn on September 03, 2006 at 11:40:57:
I've got one that I pull with that I've done it to. But you have to watch what head the pistons say to use. I have the SH/300 head and cam in mine it does snort! had the opportunity to plow with it also, did real good. 2 and 3 bottom, don't know what size of shares running 6 to7 inches deep in 3rd with each.
Replies:
Home
| Forums
Today's Featured Article -
Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|