|
Farmall & IHC Tractors Discussion Board |
Re: Belly Mower on H
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Al Dickey on July 25, 2006 at 07:14:58 from (172.167.116.125):
In Reply to: Belly Mower on H posted by Jim Joanie on July 24, 2006 at 12:33:23:
Sounds like you have picked a good combination as long as your "gently rolling" landscape is not too steep for the taller tractor and tri-cycle front end. Be careful to watch the hills for easy turn over. I have had some experience with this combo on a Cub and the only thing was stopping to shift gears. Since there is no live PTO, you must stop the PTO to shift gears. If the mower is turning at the higher RPM to mow, slow the throttle down first to lower RPM torque then stop and sfift. You may not always get the finish cut look like a newer style mower, but hey, by tommorrow no one will notice the difference. Good luck.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that�s wha
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|