Farmall & IHC Tractors Discussion Board |
Re: Water Pump pulley Adjusting Flange Replacement
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by budaa on July 24, 2006 at 20:50:25 from (24.247.55.243):
In Reply to: Water Pump pulley Adjusting Flange Replacement posted by Bobduck on July 24, 2006 at 14:59:36:
I had the same problem with my 400. Bought it with a cracked flange. First I bought a new flange which was an ORG IH PART cost was $180 just for the flange. Could not get the packing nut off either. Checked out the cost of a new water pump from from dealer was $240. The rebuilt one has the flange but they have done away with the packing nut and the fan bolts direct to the front of the pump. No springs or spacers. Also you can get an aftermarket flange if you do get the nut off for $30. I was told by the dealer in litchfield mich. So check around.
Replies:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|