|
Farmall & IHC Tractors Discussion Board |
Re: International 2400 or 454? What do I have?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on June 30, 2006 at 03:45:32 from (216.208.58.173):
In Reply to: International 2400 or 454? What do I have? posted by mattf0327 on June 29, 2006 at 14:13:21:
Matt: I am not very familiar with the 454 and even less with 2400, however I do have some decent specs for 454 in front of me. The specs I have are from a 1975 buyers guide. Model 454: 42.3 hp, 179 ci in diesel, 11" clutch, 8 forward-4 reverse synchromesh transmission, wet hydraulic disc brakes, Cat. II 3 point hitch, 540 and 1000 rpm pto. It doesn't say whether that pto is twin shaft like the larger Farmalls or two speed pto. I expect it is twin shaft. From the photo it has swept back front axle. That engine is European manufacture. About the 2400, not positive, but I think it's older and completely US built.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
