Farmall & IHC Tractors Discussion Board |
Re: Farmall C HP
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Don Mountain on June 22, 2006 at 06:52:52 from (206.72.59.149):
In Reply to: Farmall C HP posted by Ed. W on June 21, 2006 at 17:54:52:
I have a Super C that pulls a 5" Brush Hog pretty well. But I have to run it wide open in second gear, or even first to really cut thick brush. And I have to keep the blades sharp or it really draws the engine speed down. So, suggestions for you? 1. Keep the blades on the brushhog sharp. 2. Get a bigger tractor. 3. Get a smaller brushhog. Maybe 4" diameter for a Farmall C. 4. Rebuild the engine with the Super C pistons and cylinders, increasing the cubic inches, and horsepower. Also need to add a water pump to keep it cool. 5. Check to see of the governor speed is up to spec. 6. Make sure everything is greased and oiled well. Don Mountain
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|