|
Farmall & IHC Tractors Discussion Board |
Re: 806 voltage regulator
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Rhino on May 21, 2006 at 10:27:18 from (69.128.211.171):
In Reply to: Re: 806 voltage regulator posted by Bob on May 21, 2006 at 08:28:04:
Thanks Bob for replying. Yes, it looks like you see the same picture that I do. My Case IH Owners Manual shows a resistor-voltage regulator diagram just as described and I'm told the 3 terminal should be a hot lead to the regulator and then jumping to the resistor from the 3 terminal. I'm not much of an electrician but my test light says this won't work unless I'm missing something else. All my new harness sure looks to connect up nice...can't really remmeber anythig different from the old harness....but the old harness didn't seem to keep the batteries in great condition. Would apreciate anything you come up with. Rhino
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
