Farmall & IHC Tractors Discussion Board |
not sure what i should do with this M
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Paul G. in Mn on May 16, 2006 at 18:42:52 from (206.183.177.254):
I have an ealy 1939 M that I am going to restore and looking for opionions as to what I should do. My transition case is patched just below the bull gear and also have the new style lower shaft to drive the PTO. My options are 1. Raplace the whole transmion with one I have from a 1940 and change axle houseings, cover and bell houseing 2. take all the guts out of the 1940 transmition and put them in anther 1939 case I just bought 3 take the guts out of the 1939 and finding the right shaft and installing in the uncracked case all of this is alot of work, just wondering if this was your tractor wich way you would lean tward going. This tractor is all correct and complete with all the right 1939 stuff thanks Paul
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|