|
Farmall & IHC Tractors Discussion Board |
stalled international 300 utility
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by bob young on May 13, 2006 at 08:28:22 from (216.45.156.220):
i recently did a carb rebuild and tune-up. put the tractor thru some light work and parked it for a couple of hours. when i returned, i adjusted the brakes, tried to start and starter gave only one click. battery was fully charged. pulled starter and spun it when removed. got a rebuild since it looked pretty tired, installed and problem remained. removed, checked & cleaned all terminals. there seemed to be no resistance in any wires when tested. tried to manually turn the flywheel, but couldn"t get good access to it to see if it would move. the tractor was running fine, until i parked it. is there any remote chance that something seized because of my brake adjustment? anyone have any ideas?
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Generators - by Chris Pratt. As a companion to the articles on three-brush and two-brush generators, it seemed fitting that we should provide our readers with a description of how a generator works in lay terms. The difficulty with all those "theory of operation" texts is that they border on principles of electricity or physics and such. Since I know nothing of either, you will have to put up with looking at the common sense side of how generators work which means we "
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
