Re: 400 runs

Posted by Dave Slater on April 27, 2006 at 18:17:18 from (152.163.100.65):

In Reply to: 400 runs posted by super99 on April 27, 2006 at 17:25:14:

If you have all the linkage as close as you can get it to specs and it still hangs in gear. Go to the short rod that connects main clutch shaft to T/A clutch shaft and shorten it a little at a time until it quits hanging in gear. Make sure not to shorten it so much that theres no space or movement between T/A release bearing and fingers.
The bearing should not touch the fingers unless T/A lever is pulled back or main clutch realeased.
I found that it helps to bolt T/A pressure with clutch plate to carrier before installing in tractor and setting the fingers to correct specs because some are not even close.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]