Hydraulic pump Farmall C

Posted by Bill WIneman on April 19, 2006 at 15:08:35 from (71.8.247.130):

From reading the posts on the board it appears that oil getting past the worn o-ring on the C's pump drive is common. I've been "making" engine oil for the past few times I used the C to mow with so I figured it was time to get a pump kit and do the job. I figured as soon as I repaired the Touch Control unit so it didn't leak this would be the next item.

Had the local Case IH dealer order the seal kit they took the number off of the old pump and it looks like the right o-Rings etc are there. But there are also some parts that are not in the original pump. I know it is not unusual to have parts for sevral applications in one kit but I wasn't sure. I have the Blue ribbon touch control service manual but the pump diagram is limited. Any advice from those who have already went down this road? Is it difficult to get the pump shaft through the new o-ring without damage?

Replies:

• Re: Hydraulic pump Farmall C achodges1 21:37:43 04/19/06 (0)
• Re: Hydraulic pump Farmall C Peabody 19:29:19 04/19/06 (0)
• Re: Hydraulic pump Farmall C IHC Red 18:05:54 04/19/06 (0)
• Re: Hydraulic pump Farmall C CNKS 16:39:06 04/19/06 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]