|
Farmall & IHC Tractors Discussion Board |
Super C Hydraulic Pump Shaft Wear
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by lka on April 12, 2006 at 05:33:47 from (134.152.161.35):
How much is acceptable? The hydraulic pump on my Super C was leaking fluid into the crankcase so I removed it and am replacing the O-rings with those supplied in the Touch Control gasket kit. I have read on this forum that if the shaft is worn too much a speedi-sleeve is the answer but am wondering how much is too much. I measured the shaft dimeter on the smooth part and in the groove and came up with 0.623 for non-worn spot and about 0.620 in the groove. While you can see and feel this the amount of wear doesn't seem too excessive. I should note also that the O-ring seel looked to be in bad shape as it was brittle and the inside edge was hard and had several grooves in it. For reference there is a place close by that does carry Speedi-sleeves so if tat is the correct answer it wouldn't be too difficult. Lacking any other advice I am thinking of just putting it back together and hoping that the new O-ring will fix the leak. Am I inviting another rebuild by not putting a sleeve on the shaft? Thanks in advance. Lance
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Talk of the Town: The Pefect Collection - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: " I thought it would make for some interesting discussion for many of you to post what would be considered your dream or perfect antique tractor collection of five tractors, assuming room for storage and cost were not a factor. I have posted my "Perfect Collection" on the Farmall board. List any brand preference but keep
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|