Farmall & IHC Tractors Discussion Board |
Re: What Size Trailer
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bill46 on April 06, 2006 at 10:43:43 from (63.65.68.27):
In Reply to: What Size Trailer posted by DelMN on April 06, 2006 at 08:34:52:
Del, It depends on what rims you have on the 400. I have a 450D with the 2 adjustmet rings on the rims. It goes on my 20' trailer between the fenders just fine. I also have a Super M I got from dad's estate. It has only one ring on the rim...and I have to turn one wheel around to haul it anywhere. I also have a 20' gooseneck...and would rather pull it than any trailer I have. The thing is easier to balance the weight, it turns much sharper and is jut a lot easier to move in a tight place. In fact...I am thinking about getting rid of the 20" bumper pull. It is just too much weight on the rear end of the truck when empty. My 2 cents......
Replies:
Home
| Forums
Today's Featured Article -
The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|