Re: A- mag timing

Posted by Magman on March 23, 2006 at 05:11:09 from (205.188.116.133):

In Reply to: A- mag timing posted by Bill Geer on March 22, 2006 at 21:57:58:

No I believe it should be about 3 and 9 .
Get top dead center compression, trip mag just past #1 in stall mag you may have to go a little farther with the crank pulley to get it to line up. Turn mag toward motor. Then turn motor backwards about a quarter revulution to a half what you doing is making sure the mag resets back to # 1 . The turn motor over the right way slowly untill you get to the timing line stop adjust mag out wards till it trips. If it does not it could have the wrong trip member installed or the motor might be off a tooth on the timing inside.
JON

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]