Re: M Pulley Spacing

Posted by Janicholson on February 13, 2006 at 06:23:35 from (199.17.6.175):

In Reply to: M Pulley Spacing posted by NSC on February 12, 2006 at 07:20:52:

An Idea that may work is to cut a disk from stiff synthetic rubber that matches the perimeter of the pulley and would provide the spacing needed.

Sources are: Cutting mats for roller cutters (a sewing product found at cloth stores)

Borko mats from drafting tables

Offset printing press blankets.

I would think about pinning the pulleys together just below the belt groove with two roll pins to keep them from loosening in operation.

JimN

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]