super a engine questions

Posted by werowance on January 19, 2006 at 07:36:54 from (216.145.90.20):

i am going to put new mains and rod bearings.

the bearings are stamped on the back with 002 both rod and mains. is this a standard size bearing or over sized? my machine shop says standard after measuring them, but i dont trust them 100%.

also i would like to know what the oil tolerance on the rods and mains, so i can plastigage after instilation.

what are the torque specs on rods and mains.

and on the oil pump, the pickup tube swivels, i think by design. but shouldnt there be a o ring in the swivel part? or not.

thanks

Replies:

• Re: super a engine questions chip man 15:08:15 01/19/06 (1)
  • Re: super a engine questions werowance 07:51:08 01/21/06 (0)
• Re: super a engine questions El Toro 09:16:49 01/19/06 (0)
• Re: super a engine questions Janicholson 08:53:37 01/19/06 (1)
  • Re: super a engine questions captaink 09:18:44 01/19/06 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]