Re: Tune-Up for IH 330U

Posted by rumplestiltskin on January 16, 2006 at 06:06:41 from (65.216.75.240):

In Reply to: Tune-Up for IH 330U posted by Tweeter on January 14, 2006 at 07:39:07:

The last time I adjusted a set of points (30 years ago), I turned the motor over until the distributor shaft had one of its "lobes" at the "max open" position for the points. Then I inserted the appropriate size feeler gauge between the points (using the points as a spring-loaded clamp) and rotated the points-and-arm assembly until the arm just touched the lobe without releasing the gauge. Tightened the screw, started the engine, verified that the dwell angle was correct (it should be, if the point gap is right), and that was that.

I think the other replies are right about your electrical problem. If you should find that your wiring is correct, then it could be that your starter solenoid is sticking in the "on" position.

Mark W.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]