Re: Tune-Up for IH 330U

Posted by El Toro on January 14, 2006 at 08:27:09 from (64.12.116.65):

In Reply to: Tune-Up for IH 330U posted by Tweeter on January 14, 2006 at 07:39:07:

You may be using the wrong terminal on your key starter switch. There should only be voltage
to your starter when the switch is turn to the start position. When you release the key start, no voltage should be fed to the starter solenoid
that has s on the small terminal.

You can check this with a volt meter. Remove the wire from the switch that goes to your starter. Check for voltage on that terminal with
switch in the off position. No voltage should be present. Turn key to start and you should show voltage until you release the key. No voltage should be present then. You should have a terminal on the switch that feeds voltage to your ignition. This should have voltage until the key is in the off position. Hal

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]