Re: SA fan hub

Posted by Haas on January 12, 2006 at 18:21:44 from (12.65.24.183):

In Reply to: SA fan hub posted by banjo on January 12, 2006 at 10:08:52:

I'll add my 2 cents here. There is no seal on these fan hubs. The hub is designed so that centrifugal force circulates the oil and also keeps it from coming out around the shaft. A little leakage --enough to cause dust film-- is normal. Don't put in too much oil. When you took the hub apart, you should have noticed a little "stand pipe" at the oil fill screw opening. Proper procedure is to turn hub so the fill screw is on the side. Take an oil can and fill the hub until oil runs out. Then turn the opening to the bottom and let excess oil drain out. Oil will then be to level of the little stand pipe. Insert the screw in the fill hole and you are good to go. There is supposed to be a little o ring gasket under the screw head.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]