Re: Ok time to tell me how to replace the main bea

Posted by MN Scott on January 10, 2006 at 10:31:15 from (206.9.216.50):

In Reply to: Re: Ok time to tell me how to replace the main bea posted by Kelly C on January 10, 2006 at 03:52:13:

It's the IH Blue Ribbon emgine manual. If you look at your rear main bearing cap there are two holes were it meets the block on each side. They are plugged with a rubber plug and look to be about 5/16?. In the manual it shows how to install the cap with two alighnment rods. They are listed a a special IH tool. May be the tractor vet or someone will know the correct size. It also states that a slide hammer with an adapter is required to pull the rear cap off as its a light press fit.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]