|
Farmall & IHC Tractors Discussion Board |
Re: dual speed broken pto shaft
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by the tractor vet on December 30, 2005 at 16:18:51 from (4.124.95.204):
In Reply to: dual speed broken pto shaft posted by Mapleridge on December 30, 2005 at 15:28:13:
Nope , ya have to take it all apart and you will need to make up a spring compressor to relieve the spring tenshion a good set of snap ring pliers and it realy helps if ya got a cherry picker as this thing is not light and you have to be careful not to bang the pick up tube as it will be damaged when you remove the unit from the tractor . Best to get a manual . Or let someone that knowes what he is doing and has the tools and the special hdy. fitting to check pressure and set it . It takes me about three and a half hours if i have the parts and it would be a good time to put a new Hd. clutch pak in it as you are there along with new seals and gskts.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
History of the Nuffield Tractor: Conclusion - by Anthony West. In the last piece I mentioned that Nuffield had reached the stage where they had chosen to drop the "Universal" from production. The two new models were given three figure numbers, instead of "three" and "four". Model numbers were introduced to help farmers and dealers instantly recognize the engine size and horsepower of the tractor, the 4/60 had a four cylinder diesel engine which developed 60 bhp at 2,000 rpm. The 3/42 had a 3 cylinder diesel engine which produced 42 bhp at 2,000 rpm. Th
... [Read Article]
Latest Ad:
1952John Deere MT tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
