Re: C113 Engine Noise

Posted by Haas on December 16, 2005 at 18:40:25 from (12.65.0.119):

In Reply to: C113 Engine Noise posted by Dixieland on December 16, 2005 at 13:16:24:

Have you checked to know that you are getting oil to the valve rocker arm shaft?? I had this on one of my tractors. Took valve cover off and it did not look like much oil was flowing. The oil gets up there via a hole drilled in the center stud that holds the rocker arm assembly. Make sure that is open and not blocked by being in the wrong position. I took apart and reassembled and the oil flow increased a lot. Also found some crud in the lifter area at no 4 cylinder push rods where it sounded the noise was. You can see down in there with a good light. I cleaned and flushed that out and then blew it out with compressed air. I don't know which action solved the problem, but the noise is gone.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]