Farmall & IHC Tractors Discussion Board |
Re: thoughts on 706
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Short Bolt on October 15, 2005 at 21:16:17 from (69.21.20.78):
In Reply to: Re: thoughts on 706 posted by MN Scott on October 15, 2005 at 19:04:20:
John: Sounds like you did ok on the purchase of your 706 gas. Hope it turns out well for you ! But beware it won't run well on regular gas, it will knock and putt! They are really heavy for the horse power they make. The 263 was good in a 560 but the 706 is over rated. My 706 is much the same as yours, except I have 15.5x38's. Not saying you will feel the same way in a year, But I would or will trade my 706 for a good 560 in a heart beat I wished I never seen my 706!!
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|