Farmall & IHC Tractors Discussion Board |
Re: tractor under water
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by T_Bone on October 13, 2005 at 20:20:10 from (4.240.132.134):
In Reply to: tractor under water posted by Treg on October 13, 2005 at 07:47:54:
Hi Treg, I've only had a newer boat motor underwater for 48hrs, so I'll base my opinion on that. During a strom my 2yr old 8hp sheared the two 1/2" SS mounting bolts and fell into 2ft of water where it came to rest on it's side in the mud. The engine was NOT running when it entered the water. The supply air intake uses a intake reed valve just behind the carburator so it was a good seal into the crankcase area. Crankcase vacuum opens the reed valve. Upon carb removal I found a small amount of sand/silt on top of the reed valve. I removed the reed valve so I could see into the crankcase. I didn't see any sand or silt or signs of water. I pulled both spark plugs and again NO water/sand/silt. Muffler inspection revealed mud in the lower chamber but was clean to the head mount area. My conclusion: I felt pretty good that no water entered the combustion area or crankcase or transmission. The throttle twist grip, outside engine case, lower muffler was totaly filled with sand, slit and mud. The "closed" fuel line and squeeze bulb had water and dirt inside. The fuel tank was distroyed as the fuel gauge broke and let mud and water in. As it was, total time to clean was about 6hrs on this simple 2cyl engine. Since a tractor engine and transmission has no sealing method in the intake, combustion area, or transmission, like my boat motor has, I would speculate that a "total" tear down cleaning would be required of the tractors to assure any type of continued life span. Any thing less and I think you will disappointed. T_Bone
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|